Energy Power Renewables | Engineering Plastics Guides

Project guidance

About Energy Power Renewables | Engineering Plastics Guides

Read energy power renewables guidance from Jiachuang Plastics, including ground protection mats selection, project conditions and practical specifications..

The useful specification depends on axle loads, the ground under the mats, drainage, turns and repeat vehicle passes. Confirm connection details and site layout against the actual project.

View HDPE ground protection mats product details →

Energy, electricity and new sources of energy

201articles

Energy, electricity and new sources of energy

How does the wiring equipment fit on soft ground?

The topic, which revolves around the work of the tachi, line-laying and overhauling along the transmission line, focuses on “how the line-laying equipment is set up on soft ground”, analyses the looseness of the connection, drainage congestion or pollution to reduce the actual operational status and describes the selection, installation, inspection, restoration and procurement elements of the line segments, turn areas, docking positions and surfaces, respectively.

Look for details

Energy, electricity and new sources of energy

How is the width of the cabled transport road determined?

In the context of the work on the Taki, line-laying and overhaul along the transmission line, the subject is concerned with “how the width of the cabling transport road is determined”, analysing the lack of support on the edge of the road, which leads to the bending and crushing of the sheet, and indicating the selection, installation, inspection, restoration and procurement elements of the test basis and conditions in the request for and acceptance documents.

Look for details

Energy, electricity and new sources of energy

How do we maintain vehicle traffic in the power corridors during the rainy season?

With regard to the use of telecommunications, discharge and repair along the lines of transmission, the topic focused on “How to maintain vehicle traffic in the rainy season's transmission corridors”, analysing the decline in the base load and the emergence of pumping muds or faults following rainfall, and describing the elements of the selection, installation, inspection, restoration and procurement of suture, floor and vehicle operating space through representative trial workshops.

Look for details

Energy, electricity and new sources of energy

How does the construction of a mountain power tower address the entry of equipment?

The topic, which revolves around the work of the tachi, the discharge and the overhaul along the transmission line, focuses on “How the construction of the towers in the mountains will address the entry of the equipment”, analyses how static, brakes and turnovers significantly increase the local pressure and describes the selection, installation, inspection, recovery and procurement elements of the site change management using approved road maps, numbers and inspection records.

Look for details

Energy, electricity and new sources of energy

How should temporary roads for the construction of power lines be planned?

The topic, which revolves around the work of the Taki, the discharge and the overhaul along the transmission line, focuses on “how to plan for the construction of the temporary road along the transmission line”, analysing the re-routing of vehicles into deep and ground-level damage and describing the selection, installation, inspection, recovery and procurement elements that are planned for continuous coverage according to the most adverse vehicle, complete wheel and weather change.

Look for details

Energy, electricity and new sources of energy

Temporary Access Mats for Wind Farm Construction | Jiachuang Plastics

The wind and electricity vehicle entry scene is typical for analysing key points for continuous laying of soft land, heavy vehicles, turning areas and temporary roads.

Look for details