It is suggested that a short question statement be established as to how a sudden drop in the discharge of the ore material reduces the impact: the location is where the adhesive accumulation occurs and the sudden release of a group of groups, the main anomaly being that mutation in the load centre affects the stability of the vehicle, who is the target and when recovery is necessary. This distinguishes between security issues that must be immediately isolated, control issues that can be maintained, and long-term issues that need to be redesigned.
The procurement or technical staff shall first match the material type, water-bearing rate, particle size, temperature, load, car angle and current residue rate to the site photograph, indicating, in particular, the location where the mutation at the loading centre will affect the stability of the vehicle. It is proposed to improve the conditions for continuous smoothing and to unload the material in the flat area in accordance with the equipment procedure, but the length, width, thickness, weight, surface, hole and permitted temperature of the slabs will still need to be checked prior to implementation. Where products need to be relocated repeatedly, the ceiling for manual removal and mechanical posts should also be included in the selection.
Figure : Sudden release of mucus after accumulation.
The quality of the installation should be reviewed through photographs and measurements, not just oral confirmation. First, it handles drainage, tatters or deformation steel plates, and then places the skating of cars on approved drawings; the low friction liner is to be used with the correct lifting and clean-up system. Any need for temporary blocks of wood, random cutting of angles, forced porosity or stacking should be returned to the technicians for re-evaluation.
The shift should be accompanied by a clear reporting of changes in seams, sudden slips, overloading and lifting anomalies, rather than a description of the current appearance. Connections, feed points or seams processed in the previous class are reviewed in the next class, and abnormally close rings are formed. During the clean-up process, it is prohibited to treat polymer surfaces with fire, violent banging or sharp shovels to avoid creating new vulnerabilities.
Receiving and inspection information shall keep the product batch, installation chart, site photographs, initial dimensions and trial running records. In the event that a future mutation in the loading centre affects the stability of the vehicle, it is possible to determine whether the anomaly arises from initial installation, changes in condition or natural wear. For reusable pavements or leg pads, this set of records will also facilitate the rapid matching of suitable locations for the next transfer.
The conclusions can be summarized as identifying the boundary before choosing the slab, which will then be validated by checking data. Products shall not be used as substitutes for unsatisfactory foundations, damaged equipment or illegal operations. Where a person is involved in entering a dangerous area, a stop, quarantine and locking procedure shall be carried out; where a load and stability are involved, a review and written basis shall be carried out by a qualified person.
Need for further evaluation of the actual project?
Applications, sizes, quantities, site photographs or drawings and delivery destinations are sent, on which we can identify more suitable products and processing programmes.
